MCC MIIC-203 Spécifications

NORTH AMERICA: 800 498-JDSU (5378) WEBSITE: www.jdsu.comWORLDWIDE: +800 5378-JDSUSFP+ Evaluation BoardApplication NoteTable of Contents1Introduction..

5.2.2 SFP+ Control Jumpers JP3, JP4 and JP5• JP3: TX_ENABLE; If this jumper is left open, the TX is disabled. The state of this pin is indicatedby D2.

6.1 Power SupplyTwo (2) LEDs indicate RX power and TX power have been applied.• VR+: VCCR; Indicates power has been applied to the RX (LED D10 Green)•

6.3 SFP+ Monitor and ControlFour (4) LEDs indicate various module parameters.• RXLOS: RX_LOS; Indicates Loss of Signal at the RX when illuminated. (LE

8 ESD PrecautionsNormal ESD precautions are required during the handling of this equipment. The transceivers andevaluation boards are shipped in ESD

Cover the workbench surface with a conductive mat with a surface resistivity of 104to 108Ω/sq, for aresistance between surface and ground of 7.5 x 105

9.1 Cleaning Optical Connectors with Wipes, Swabs and Isopropyl AlcoholThe following items are required:• Canned Air (Clean, dry, oil free compressed

16Application Note: SFP+ Evaluation BoardTable 4 Applicable Standards Related to SFP+ ModulesSignaling High-Speed Low-Speed Optical Management Mecha

11 Schematic17Application Note: SFP+ Evaluation BoardFigure 10: Evaluation Board Schematic

12 Component Placement Drawing18Application Note: SFP+ Evaluation BoardFigure 11: Component Placement Drawing

19Application Note: SFP+ Evaluation BoardNORTH AMERICA: 800 498-JDSU (5378) WEBSITE: www.jdsu.comWORLDWIDE: +800 5378-JDSU13 Card Dimension Drawing

Section 8 explains ESD precautions that should be observed when working with any sensitive electro-optic device. Section 8 explains optical connector

4 Evaluation Board OverviewThe evaluation board has been designed to allow for the complete characterization and testing of allJDSU SFP+ optical tran

4.1.2 Power SupplySFP+ devices are hot-pluggable and can be installed when the power is active. Set the power supply toachieve 3.3 VDC at the Transcei

5.1 ConnectorsThe evaluation board is pre-configured for use with any SFP+ transceiver. The shorting jumpers arepre-installed. Many of the jumpers hav

6Application Note: SFP+ Evaluation BoardTable 1 JDSU EMI-Enhanced CagesPart Number Pin Length Description Minimum PCB ThicknessSingle-Sided Belly-to-

7Application Note: SFP+ Evaluation BoardFigure 5: JDSU EMI-Enhanced Press-fit 1x2 Cage with light pipesFigure 3: JDSU EMI-Enhanced Press-fit CageFigur

5.1.4 J4: SFP+ ConnectorSome SFP edge card connectors may not be compatible with higher speed SFP+ applications. SFP+connectors for 8.5 and 10 G appli

9Application Note: SFP+ Evaluation BoardTable 2 Description of pins on DB-25 Connector J5Pin Label Description1 VCCR Provides access to VCCR, can be